5
E105026#1
20
83
8
8
100
5. Planning and making overview:
5.1 Assembling the hinges, sides and door.
5.2 Planning and making the case
5.3 Soldering the metal strip on the drive shaft and adding the motor connections.
5.4 Assembling the gearbox
5.5 Mounting the gearbox and mechanism
5.6 Planning and making the switches
5.7 Making the switch panel
5.8 Wiring the circuit
5.9 Testing
5.10 Gluing the shelf in position
5.1. Assembling the hinges, sides and door:
• Screw (33) the hinges (31) on the door (5) according to the measurements as shown.
• Insert the screw eye (26) in the door as shown.( use a bradawl to start the hole)
• Mark out and glue the supports (2) and (4) where indicated by the shaded lines on to one of the
side parts (8). Finally mount the door on to the side.
40
10
10
10
side part
Door
33
26
5
33
31
8
