2
D112765#1
Ø 40
Ø 3
Ø 4
Ø 4
Ø 3
Ø 4
Ø 4
Ø 40
150
125
25
INSTRUCTIONS
1. Trace the patterns ( Page 5) on to the aluminium sheet (1)
die Schablone Mark the holes with a centre punch!
Please note:
The broken lines are the folding lines. When tracing the pat-
terns on the aluminium sheet , start by tracing the solid lines
only , so that thee is less likelihood of any mistakes.
Base stage
Cover
Lid
lower stage
Middle stage
Lid
Base
Cover
2. Drill all the holes 3/ 4 mm dia Remove any sharp edges with a countersink bit. The various parts (Lid, Cover , Middle
stage, Base) should be sawn eith a fretsaw ( with metalworking blade ) Remove the burr from the sawn edges with a
file. The central hole in the lid, middle stage is drilled out to allow the insertion of the saw blade. Saw out the shape and
remove burr
10
10
3. Take two brass tubes (8) mark off 10mm
and them saw to length. Remove any burr
with a file. At the end you should have 4
tubes each 10mm long, with smooth ends
.
Preparing the various parts:
4. Shorten the threaded rod (4) as shown in the
diagram. Remove any burr from the ends
General:
The lantern can be made in two variations. These instructions describe the first variation. In Variation 2 the top part is diffe-
rent and the metal must be formed into a rounded shape
Making the spacer tubes for the bottom and top
1b
1a
1c
1d
