3
D112765#2
INSTRUCTIONS
Bending:
5. Draw out the folds ( broken line )
from the pattern (Page 5) with a
pencil (see diagram)
6. Place the metal in a vice with jaw protec-
tors. In order to bend the sides you will
need a 10mm thich piece of strong wood,
without this you will not be able to bend
the last side.Firstly bend the the 4mm
tabs.Mark out the metal sheet and bend
as shown
7.Once the 4mm tabs are bent, then mark
out the 8mm tabs and set them up for
bending.Bend the 8mm tabs taking care
not to bend any previously bent tabs
Note bend all the tabs in the same direc-
tion
Assembly
11. Screw a domed nut (6)
on each of the 4 threaded
rods
12. Place the base (1a) on the
four threaded rods so thet
it rests on the four domed
nuts
13. Then add 4x 10mm-
metal tubes on the
threaded rod
14. The add the lower stage
(1b) with the tabs upwards
9. On the acrylic sheets (2) (Middle) ,mea-
sure and mark out as shown
75
75
150
10. Cut the acrylic sheet in two and then
clean up the sawn edges
2x
4mm-Tabs
8mm-Tabs
1a
1b
8. Bend the tabs in the lid in the same
direction as shown.
10mm
