2
D208257#1
2
32
13
6
8
54
69
123
33
93
173
Step 1:
Cut the cut-outs a and b out of
the base plate with a craft knife.
Instructions
a
b
Step 4:
Glue the switch (4) in the cut out b, as
shown!
glue
glue
glue
glue
Step 2:
Cut in a hole width at the ends of the
base plate (solid lines) as shown. Fold
the ends inwards.
Step 3:
Coat the bent up ends with glue,
fold up the sides and hold them with
paper clips.
PVC-tube
(5mm)
PVC-tube
(5mm)
Step 5:
Cut off four approx. 5 mm long pieces from the PVC hose (12). Loosely
place the rubber ring (10) on the pulley wheel.
Place the pulley wheel (9) as shown (recess a).
Slide the axis (7) through the hole in the base plate and attach a piece
of PVC. Then push the axis through the wheel and attach another
piece of PVC. Now push out the axis on the opposite side (as shown).
Center the axis using the PVC pieces and place the wheel in the
middle of the recess. Glue it down if necessary (see illustration). After
centering push a piece of PVC on the axis (7) on each side. Be careful
not to compress the cardboard.
Step 6:
Cut off four approx. 5mm long pieces from the PVC
hose. Slide the axis (8) through the hole, insert 2 PVC
pieces and lead the axis out again on the opposite side.
Centre the axis (8) and push a piece of PVC on each side
of the axis from the outside. Be careful not to compress
the cardboard.
PVC-tube
(5mm)
7
8
