3
D208257#1
3
M
circuit diagram
battery
switch
motor
Step 10:
Fasten the battery holder (3) with hot glue as shown.
Wire everything according to the circuit diagram (see above). Con-
nect the red cable of the battery holder to the positive pole (marked
with a circular recess) of the motor. Cut off an approx. 80mm long
piece from the jumper wire (5). Strip insulation on both sides and
connect it to the external switch connection and to the motor
connection (-). Connect the black cable of the battery holder to the
middle switch connection.
Please Note.
If the vehicle reverses, simply switch the motor connections!
Instructions
Step 7:
Put the reducer (11) onto the motor shaft as shown.
Ill. A
Step 8:
Glue the motor into the base frame with hot glue gun in
such a way that the rubber ring (10) is tightened when it is
placed on the reducing piece (11) of the motor shaft.
Step 9:
Cut out the individual parts from the enclosed template and glue them together at the fishplates. Cut holes (5 mm) for the
axles (see marking) with hole punch. Place the finished model on the base plate and glue it to the side parts of the base plate.
Cut off protruding body parts with scissors.
rubber ring
