Opitec 208.257 Quick Start Manual Download

Page: 4 / 4

D208257#1

Step 11:

Glue two cardboard wheels (3) together.

Then cut both wheels out of the templa-

te and punch out the openings with the

punch pliers. Then glue the wheels onto

the double wheels (3).

Step 14:

Done!

Insert an AA 1,5 V mignon battery. The

vehicle will start moving when the switch

is switched on!

Step 12:

Fit the two wheels on both sides of the

axle, align and glue them to the axle!

Instructions

Fahr

trich

tung

Step 13:

Cut out 4 pieces 25 x 50 mm each from a

piece of cardboard (approx. 100 x 50 mm).

Fold in the middle and glue as reinforce-

ment from below to the "nose" and tail as

shown in the illustration. Cut off excess

cardboard.

Summary of Contents for 208.257

Page 1: ...c t i o n a l M o d e l E l e c t r i c C a r Required Tools Pencil Ruler Scissors All Purpose Glue Side Cutters Craft Knife Wire Strippers Hot Glue Gun Hole Punch Piece of Cardboard approx 100 x 50 m...

Page 2: ...l 9 as shown recess a Slide the axis 7 through the hole in the base plate and attach a piece of PVC Then push the axis through the wheel and attach another piece of PVC Now push out the axis on the op...

Page 3: ...battery holder to the middle switch connection Please Note If the vehicle reverses simply switch the motor connections Instructions Step 7 Put the reducer 11 onto the motor shaft as shown Ill A Step...

Page 4: ...AA 1 5 V mignon battery The vehicle will start moving when the switch is switched on Step 12 Fit the two wheels on both sides of the axle align and glue them to the axle Instructions Fahrtrichtung St...