3
7
8
Glue together the wooden parts (1g, 1h, 1k) to the body of the worker
as shown above.
Note: The holes in the side panels must be exactly aligned
(Insert screws).
10
Then attach the gears to the axles of the gearbox as shown above.
Note: Screws must be offset by 180 °!
12
Then fix the thread in the body as shown with the two screws (8) and
two nuts (13).
Slide the metal axle (5) through the holes in the axle brackets and
attach a steering wheel (12) from both sides.
11
Lead the cables of the battery holder (5) from the front through the
hole in the body. As can be seen in detail, solder on the motor connec-
tions.
5
12
12
1g
1h
1h
1k
9
Place the gear wheels on top of each other so that the cross openings are
aligned. Then insert a screw (9) as shown. Unscrew 3 nuts each from the
opposite side and attach a washer (15). (important, otherwise the offset is
not 180 °.
7
9
13
13
15
15
Detail
8
Building Instruction 120.830
Running worker with wheelbarrow
