Oplink Communications
3.3 WDS+AP Mode
In this mode, the device can enhance the signal and extend
the wireless coverage. It can bridge two local area
networks or two computers and meanwhile amplify and
transfer the signals. The WDS+AP mode is similar as
WDS mode. Besides, many wireless clients can access
when the device works as a bridge.
3.4 WISP Mode
In this mode, you do not need to configure the signal
transmitter but only to simply configure the W150M to
amplify the wireless signal and multi computers can share
the internet. The device supports DHCP function to assign
IP addresses automatically and NAT function. If you
enable the WISP outside the house but the inside WISP AP
signal is poor, the device can enhance the signal and
improve the speed. If more than one wired computer
access, you can connect the LAN port of the device to the
switch and the switch to the computer.
The network topology is as follows.
