Oplink Communications
cable directly.
Note: In this mode, the LAN/WAN port is worked as the
WAN port. After it takes effect, only the computers with
wireless network adapter can access the web-based
interface of the router.
Log on the web-based interface as chapter 4 and then
configure the mode as below.
5.5.1. Select “Wireless Router”, click “Setup Wizard” and
“Next” button.
5.5.2. Configure the parameters.
This device supports three kinds of access ways
(ADSL virtual dial-up, dynamic IP, static IP); please select
the ways according to the actual situation. If you are not
sure, you can consult local Internet service providers to get
the relevant parameters.
¾
Dynamic IP (DHCP)
The default access method is Dynamic IP. If your ISP