Biopel line
– Ethernet module
4
After a short time, the screen module appears.
1.3 Setting security protection
If you want to change the user name and password for access to the module, then it is necessary to enter the
Settings tab which is on the top right corner of modul
’s online page.
Setting security protection module in a local network.
We set up a new user name and password.
After approval by clicking on the icon a confirmation message appears.
1.4 Manual adjustment module
One way to configure the master controller v8 to the local network is manually set the access parameters.
In this case, we have to check the settings for your local network.
We will need the following parameters:
o
IP Address
o
Mask IP
o
Gateway Address
o
DNS Address
1.4.1 Downloading data
Click on the Start menu, then Run (or Win key + R)
c: \ Windows \ system32 \ cmd.exe
Please enter a cmd and click OK
A window opens with the console.
Type ipconfig and press Enter.
In most cases, the same DNS address as the gateway address. For certainty you can check this by using the
command typing in ipconfig / all
1.4.2 Configuring control unit v8
After entering all the data that we need for setting master controller we enter into settings for an Internet module in
the boiler controller (menu >> Plumber settings >> internet module).
Parameter DHCP (Eng. Dynamic Host Configuration Protocol) must be turned off.
