Biopel line
– RT10 room regulator
6
Operation mode view - shows the active pump operation mode (view active only when a pellet furnace
is used)
– by pressing this panel you can change the pump operation mode. You can select any of the
following pump operation modes: home heating, water heater priority, pumps in parallel, summer mode
with heating up and summer mode without heating up. A detailed description of the pump operation
modes can be found in the instructions manual of the furnace controller.
1.1 Thermostat menu
During normal operation of the thermostat the graphic display shows the main page. After pressing the
menu button the user can access the individual functions of the controller. The arrow buttons are used
to navigate the main menu.
1.2 Describtion of controller functions
1.2.1 Time
After pressing the Time icon in the main menu a panel will be displayed that can be used to change
clock settings, the current day of the week and alarm clock settings.
Clock settings:
You can use this function to set the current time for the thermostat.
Setting the current day of week:
