I N S T A L L A T I O N
9
Changing the Remote Code
The remote control supports one of three remote codes. The default is “Code 1”. If you have other OPPO
products placed close to the BDP-95AU, they may inadvertently respond to the BDP-95AU remote control.
In this case you can select a different remote code to avoid conflicts.
To select a new remote code, open the battery compartment cover of the remote control, and then use a ball
point pen to flip the switch to one of the positions marked as “1”, “2”, or “3”. Close the battery compartment
cover. Make sure that the BDP-95AU player is turned on and
the disc tray is ejected
. Aim the remote control
at the player. Press and hold the ENTER button for 5 seconds. The player will start using the new remote code.
Remote Code Switch
Battery Compartment
CAUTIONS
Never drop the remote control or expose it to moisture.
Never expose the infrared remote sensor on the front panel to direct sunlight or other
strong light sources.
Remote may not operate consistently when batteries become low. Replace them if
operation deteriorates.
If the remote control will not be used for a long time, please remove the batteries.
Use the batteries correctly to avoid possible leakage and corrosion. Do not leave the
batteries exposed to direct sunlight or high temperature environment for a long
period of time. Do not heat or expose to flame. Do not mix old and new batteries.
Do not use batteries of different types at the same time. Do not attempt to recharge
the batteries.
If battery leakage occurs, do not touch the liquid with bare hands. Wipe out any
liquid inside the battery compartment, and insert new batteries.
x
x
x
x
x
x
Summary of Contents for BDP-95AU
Page 1: ... USER MANUAL READ CAREFULLY BEFORE OPERATION Blu ray Disc Player BDP 95AU AU ...
Page 2: ......
Page 89: ...51976538 V1 0 ...
Page 90: ... ...
