The information and specification in this document are subjected to change without notice.
© 2017 Optec Technology Ltd. All rights reserved.
4.0 Disassembly Procedure
①
Assemble the wedge clip.
②
Unlock the fiber.
③
Open the rear cover aside.
④
Pull out the fiber and reassemble
the rear cover.
** Assembly repeatability is more than 5 times with proper handling
Installation & Assembly Instructions
SwifTerm™ Field Installable SC Connector – No Polish / No Epoxy
Optec Technology Limited.
Unit 1701, 17/F., North Tower, World Finance Centre, 19 Canton Road, Kowloon, Hong Kong.
Tel: +852-2301-8148 | www.optec.com.hk | sales@optec.com.hk
3.0 Assembly Procedure
Insert fiber
along the C-slot
Arrow logo facing up
Be sure fiber bend does not exceed
1.0mm above the C-slot
Slide the wedge clip towards front
①
The wedge clip is locked with
connector body. Open the rear part as
shown in diagram.
②
Insert the cleaved fiber slowly into
the rear of connector until connection
is made.
③
Make a bend in the fiber to
maintain connection. Close the lid
when done.
④
Release the wedge clip and
complete.
** Keep the ferrule’s dust cap on until ready for installation
Open the
wedge clip
Doc No: MKD-B001-17
Page 2 of 2
