background image

 

5

SPECIFICATIONS 

Note: Product upgradation is a continuous process; hence specifications are subject to change without notice. 
 

SAFETY 

THE UPS CONTAINS VOLTAGES WHICH ARE POTENTIALLY HAZARDOUS.

 

QUALIFIED SERVICE 

PERSONNEL SHOULD PERFORM ALL REPAIRS. 
THE UPS HAS ITS OWN INTERNAL ENERGY SOURCE (BATTERY). THE OUTPUT RECEPTACLES MAY BE 
LIVE EVEN WHEN THE UPS IS NOT CONNECTED TO AN AC SUPPLY 

 
TROUBLE SHOOTING 

The trouble shooting chart covers most of the difficulties that you may encounter under normal working conditions. 
If the UPS fails to operate properly, please review the following steps before calling the service center. 
1.  Is the UPS plugged into a correct working outlet? 
2.  Is the line voltage within the rating specified? 
3. Is 

the 

fuse/circuit 

protector on back panel open? 

 
Please submit the following information when you call for service. 

1.  Model No. & Serial No. 
2.  Date of problem. 
3.  Full description of problem. 
 

MODEL 

TS500D TS600D TS625D

TS650D

TS700D

TS800D

TS850D TS1000D  TS1200D 

Voltage 110Vac/115Vac/120Vac/220Vac/230Vac/240Vac 

Input 

Frequency 50Hz/60Hz±5% 

Frequency 50Hz 

/60Hz±5% 

Voltage 110Vac/115Vac/120Vac/220Vac/230Vac/240Vac 

Transfer time 

<10ms including direction time 

Output 

Wave form 

Sine wave under mains supply, square wave under battery operation 

RS-232 interface (Optional) 

 

yes             

 

NO 

Surge protection (Optional) 

 

RJ11         

 

RJ12       

 

RJ45

 

Overload 

As load over 130%, UPS is protected in 3 seconds 

AC input 

Fuse for overload & short circuit   

Protection 

Short circuit 

UPS Auto-shutdown 

Type 

Sealed, lead acid maintenance-free   

protection 

Auto-inspection, discharge protection and battery fault caution 

Battery 

Battery   

Battery should be charged once every three months, not less than 6 hours once a time. 

Sufficient battery capacity, buzzer rings every 4 seconds, red light flashing 

Battery mode 

Insufficient battery capacity, buzzer rings every 1 seconds, red light flashing 

Audible 

alarm 

low Battery or 
overload/short 
circuit  

Buzzer keeps alarming, red light on 

Weight(kg) 5.8/6 

5.5/6 6.2/6.4

6.4/6.7

7.9 8  8.5 

10.5 11 

Physical 

Size 
(LxWxH)mm 

340x90x140/375x142x200 330x102x152 

340x122x190 

Summary of Contents for Thunder Shield TS500D








Reviews: