OPTICAL SYSTEMS DESIGN
DOC ID: 10115304
OSD2251P OPERATOR MANUAL
PAGE 21
2.5.2
COMMAND LINE FUNCTIONS
There are a number of command line functions that enables the user to obtain running information of a
single OSD2251P unit or the complete topology of the ring/bus network. This section explains the
command lines and its functions.
When the terminal emulation program is operating, connect the USB cable to any one of the
OSD2251P units on the ring/bus network – or alternatively, the OSD2251P unit which the user wishes
to interrogate. Note: A message will be displayed on the terminal emulation program when the unit is
powered after USB connection. This message will not open when the unit is switched on while
plugging in the USB cable, however the command lines are functional.
The following table outlines the user available command line commands and their functions
TABLE 6: TERMINAL COMMAND LINES
TERMINAL
COMMAND
LINE
SPECIFICATION
FUNCTION
FIGURE
?
Help
Lists all CLI commands including
input format information
-
vc
Version Check
Displays the current software version
and revision installed on the unit
Figure 18
ds
Default Setting
Reset configuration to default
Figure 19
ipconfig
IP Configuration
Configure the IP address
Figure 20
tc
Topology Check
Displays the topology status of the
established ring/bus
Figure 21
nc
Node Check
Gets running status of the node for
given MAC address
Figure 23
lnc
Local Node Check
Gets running status of the local node
Figure 24
fbe
Float Backup Enable
Enable float backup function for all
nodes in a Ring/Bus
Figure 25
fbd
Float Backup Disable
Disable float backup function for all
nodes in a ring/bus
Figure 29
node_ip_set
Node IP Set
Setup IP of the node with given MAC
address
Figure 32
node_all_set
Node All Set
Setup IP for all nodes on a ring/bus
Figure 33