Installation
Important: Please keep the installation procedure below. Failure in
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents in the shipping group.
Step 2
Power on the HDMI source and display. The external power is recommended
for the stable power supply for both the transmitter and receiver.
Step 3
The Power LED will be turned on and the Status LED will blink three (3)
times. Then the Status LED will blink again when the whole connection is
made.
Figure 2
– Position of the LED
Step 4
Connect one (1) LC optical fiber between the transmitter and the receiver.
Ensure the connectors are fully engaged and then, the top LED will begin to
blink regularly.
Step 5
Connect the transmitter and the receiver to the source and the display
respectively via 2m copper cable provided in the shipping group.
Note:
If the connectors are fully engaged, the bottom LED will turn on.
1-3 Installation
Note:
If HDFX-500 module is used as its pair for HDFX-700, connect HDFX-
500 module directly into the HDMI port on the source or display.
Fig Figure 3
– Connection of optical fiber
Step 6
If the system does not work properly, go to the page 1-5 for trouble shooting.
Note1:
Please DO NOT look directly into the LC receptacles of the
Transmitter, while it is powered on. Although this product is regulated strictly
enough to operate under the LASER Class I, classified by CDRH/FDA for eye
safety, it is not recommended to do so.
Note2:
The maximum extension length by OM3 fiber is 200 meters (656ft.).
Note3:
It is recommended NOT to use any intermediate cable or adapter that
is not provided in the shipping group between the modules to avoid
undesirable performance degradation.
1-4 Installation
Position of the LED
