Step 4
Remove the module dust covers and connect each duplex LC fiber cable one
by one to each of 8 LC receptacles of the Transmitter and Receiver boxes, as
shown in Fig. 4. Plug A to A and B to B. Carefully recheck polarities and
ensure the duplex connectors are fully engaged.
Step 5
Connect each RJ-45C of the DDC cable to each RJ-45C receptacle of the
Transmitter and Receiver boxes.
Figure 4 – Connection of 4 duplex LC fiber cables and a DDC cable
Step 6
Connect an AC/DC power adapter to either of the Transmitter and Receiver
boxes as your availability of AC outlets.
Figure 5 – Connection of AC/DC power adaptor
Step 7
Power on the PC and display.
Tip 1:
After initial installation as guided in the above, we recommend you to
power On and Off while all connections are set and the Tx/Rx boxes are
powered in.
Tip 2:
Avoid “hot plugging” the Tx or Rx boxes as this is not recommended
practice with live digital voltages.
1-2 Installation (continued)
Troubleshooting
The display displays only black screen.
•
Check that all AC and DC plugs and jacks used by external power
supplies (both Opticis and others) are firmly connected.
•
Ensure that power bars are live.
•
Ensure that the Tx and Rx boxes plug correctly to the PC and display,
respectively.
•
Check if the PC and display are powered on and properly booted.
•
Re-boot up the system after reconnecting the optical system cable.
Screen is distorted or displays noises.
.
•
Reset the system.
•
Power down, disconnect the LC-LC fiber cable and try to blow inside
of each LC receptacle by air blower
•
Reconnect the fiber cable and power up.
•
If noise continues, please contact the following.
Maintenance
No special maintenance is required for the optical system cables and power
supplies. Ensure that the cables and power modules are stored or used in a
benign environment free from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis or its authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
techsupp@opticis.com
or visit its
website at
www.opticis.com
.
1-3 Troubleshooting, Maintenance, Technical Support
