OPN-2102i
1st
19
SPECIFICATIONS MANUAL
10 Regulatory Compliance
10.1 LED Safety
JIS C 6802
：
2011 Class 2
IEC 60825-1 Ed.2: 2007 Class 2
CDRH Class
Ⅱ
10.2 Product Safety
EN60950-1:2005
IEC60950-1:2006
10.3 EMC
R & TTE Directive
・
EN 55024:2010
・
EN 55032:2012+AC: 2013
・
EN 301 489-1 V1.9.2
・
EN 301 489-17 V2.2.1
・
EN 300 328 V1.9.1
・
EN 302 291-2 V1.1.1
FCC Part 15 Subpart C, Subpart B ClassB
Federal Communications Commission Notices
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This product complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Harmful Interference Notice
This product has been tested and complies with the specifications for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which is found by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
