11
The correct sequence to retrieve the data from the OPN using the mini USB cable would
then be connecting your OPN to the USB port, clicking on the NetO32 configuration file and
then remove the OPN from your PC when desired.
Don't forget your OPN needs to be regularly charged as well.
10
Loading software on the OPN
The following chapter will describe how to load new software onto the OPN.
Important note: When installing a new Operating System on the OPN any barcode data
left on the device might be lost!
10.1
Software codes
All OPN terminals run an OS (operating system) and an application. Both the OS and the
application can be loaded by a small PC application called Appload, which can be download
from our web site.
The OPN terminals use an Operating System version that contains an unique 3 letter code.
Before you try to load a new Operating System on an OPN terminal you have to know
which Operating System file (i.e. RBFVxxxx.hex) must be loaded on your terminal.
In the table below you can find the software codes for the OPN200x terminals.
Terminal
OS
Application
OPN2002
RBG
RFG*
OPN2003
RBF
RFF*
OPN2004
RBI
RFI*
* It is often possible to load OPN2002 applications on the OPN2003 and vice versa, because
the hardware is mostly the same (besides Bluetooth capabilities and cradle contacts that
are only present on the OPN2002).
10.2
Loading software using the mini-‐USB cable
To be able to load software on the OPN using the mini USB cable first make sure you’ve
selected the USB-‐VCP interface (see chapter 3.1), because USB-‐MSD is not yet supported to
install software. Also make sure you have the USB-‐VCP driver installed on your PC (see
chapter 7.1).
10.3
Loading software on the OPN2002
To load a new OS or application onto the OPN2002, you'll need a mini-‐USB cable (which is
supplied with the OPN2002) or the CRD2000 cradle.
Summary of Contents for OPN2002
Page 19: ... 19 ...
