Welcome!
Congratulations on your purchase of the two (2) fibers HDMI 2.0 extender,
HDFX-350-TR. This manual contains information that will assist you in
installing and operating the product.
Product Description
Our compact optical HDMI 2.0 extender, HDFX-350-TR enables to transmit 4K
UHD (4096x2160) at 60Hz signal up to 200m (656feet), avoiding any tricks
such as scaling or data compression that reduces the quality of data
transmission. It provides total data rate of 18Gbps (6Gbps per lane).
The OM3 fiber connection of two (2) LC multimode fibers between the
transmitter and the receiver, gives a clean, secure and easy installation with
perfect electrical isolation, yet without electrical hazard and interference.
HDFX-350-TR can be operated by USB power by plugging the USB cable, and
HDFX-350-TX can be operated by DDC 5V from pin #18 of HDMI interface (Tx
side ONLY).
Figure 1 – Overall Connection of HDFX-350-TR
System Requirements for Setup
□
Hardware requirements
▪
You must have a HDMI source and a display. It should support
the maximum graphic resolution feature of displays for the use.
▪
No special requirements for the memory size, CPU speed and
chipsets, if you have already properly installed your HDMI
systems or graphic cards.
▪
Proper initial trial of the entire platform with its application using
a short length copper cable on Tx side is recommended prior to
the installation with the device. In case of using copper, please
contact regional distributor or Opticis for assistance.
□
Software requirements
▪
No special restrictions, if you have already properly installed
your HDMI systems.
□
Power Technical Advisory
▪
Enclosed Power Adaptors and USB cables should supply
enough power on both Transmitter and Receiver.
□
Connection Advisory
▪
It is highly recommended that HDMI source is directly
connected into HDMI display output via HDFX-350-TR
without connection to incompatible distributor, switcher
and selector.
The Shipping Group of
HDFX-350-TR;
One (1) Transmitter (Tx) and One (1) Receiver (Rx)
Two (2) Micro USB to USB cables
Two (2) DC +5V, 1A power adapters
One (1) User’s Manual
One (1) customized HDMI cable (0.2m) - Optional
