Installation
Important: Please use the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly as followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug directly DVI plug of the Tx side of DVFC-100 into the DVI receptacle of
DVI source (PC graphic card etc.) without power up of display devices. It is
NOT
recommended to use any intermediate cable or adapter between them.
It may deteriorate the signal transmission performance.
Step 3
Plug DVI plug of the Rx side of DVFC-100 into DVI receptacle of a Display
source. It is
NOT
recommended to use any intermediate cable or adapter
between them. It may deteriorate the signal transmission performance.
Step 4
Power ON both DVI source and display devices and check the blue power LED
on Tx and Rx ON.
Step 5
If the system does not work properly, go to page 1-4 for the troubleshooting.
Note:
DVFC-100 can utilize either the +5V power supplied through a DVI pin
(#14) from the DVI source or the +5V power adaptor. Nonetheless, you have to
confirm the power being capable to supply more than 500mA.
Note:
Many DVI sources are able to supply sufficiently DC power to operate
DVFC-100.
1-3 Installation
Troubleshooting
The display displays only black screen.
Ensure that the DVI ports are firmly plugged in to the DVI source and display.
Ensure that the Tx and Rx module plugged correctly to the DVI source and
display respectively. Ensure that blue power LED on Tx and Rx module are
live.
Check if the DVI source and display are powered on and properly booted.
Reset the system by de-plugging and re-plugging the Tx DVI port or Rx DVI
port.
Re-boot up the system while connecting the optical DVI cable system.
Screen is distorted or displays noises.
Ensure connections of both plugs while disconnecting and reconnecting the
optical DVI cables.
Maintenance
No special maintenance is required for the optical DVI cables. Ensure that the
cables and power modules are stored or used in a benign environment free
from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
techsupp@opticis.com
or visit its
website at www.opticis.com.
1-4 Troubleshooting, Maintenance, Technical Support
