2
Optika
stereo-microscope
LAB-1 / LAB-2
INTRODUCTION
Ryeco Stereomicroscopes series STEREO, LAB 1 and LAB 2 are high level stereomicroscopes with
objectives 2x-4x (LAB 1) or zoom 1x4x (LAB-2). The magnification is from 5x to 12Ox by using
additional lens (optional).These stereomicroscopes are the good choose for the professional user.
Unpacking and assembling of the microscope
The components for series stereo Ryeco LAB-1 and LAB-2 are shipped detached for protection. open the
Styrofoam packing with care and do not leave any components attached to the packing being removed. Do not
discard any of the packing materials until all components have been located. lf damage occurs during transit,
contact both the carrier and your supplier immediately.
When handing the components, especially all the optical parts, avoid touching any lens surface with naked hand or
fingers. Any fingerprints or grease stains will negatively affect the image quality (see Ryf Cleaning Sets).
After unpacking the stand, put it on a good stable table. Loosen the lock screw of the focusing carrier, adjust the
height of the focusing carrier and lock the lock screw again. Make sure that the support collar is secured firmly
below the focusing carrier along the vertical post This is important as this collar functions to avoid the accidental
falling of the microscope along the column.
