16
3. Aim the mark point on the upper cap at the mark point on
the squeezing cup, then install into the squeezing cup as
figure. See Fig. 5 a,b.
4. Insert the extracting rod to the middle of screen holder
while the extracting rod is rotating. See Fig. 6.
5. Place the triangle mark of the juice mouth aim the dot of
the squeezing cup,then rotate the juice mouth with “off”
direction(clockwise) until the “on” mark aim the dot on the
squeezing cup,now the juice mouth is in juice open mode.
When you need take away the juice cup,you must wait
until the juice inside the squeezing cup drain away or juice
drop state,then rotate the juice cup with “on” direction
(counterclockwise) until the “off” mark aim the dot on the
squeezing cup,now the the juice mouth is in close mode to
avoid the juice drop on the table.Before juicing again,you
should rotate the juice cup with clockwise direction to
make the “on ” make aim the dot on the squeezing cup.
See fig. 9 a,b,c.
a
c
b
d
a
b
Fig. 4
Fig. 5
➁
➀
The fixer should have sealing ring
Summary of Contents for OP-2200
