Instructions for Use and Maintenance 151-191 (1310)
trejonindustries.se
18
Breddningsvingen
monteras på
insidan av
maskinen
Support pads
The height of the equipment is adjusted with two supporting pads located at the back. The
angle of the equipment is adjusted with the top-link. This determines the how well the
equipment follows the variations in the surface. If the equipment is angled forward, it is easier
for it to cut through packed snow and ice. A suitable basic adjustment when the machine rest
on the support pads, is that the wearing edge of the scraper steel is 10mm above ground. Aim
at keeping the machine levelled during work.
The supporting pads are to be adjusted as the wearing edge is being worn down. The
supporting pads are adjusted by undoing the mounting screws, and mount them in other
holes.
Ejector tube
The equipment comes fitted with a hydraulically turntable ejector tube as standard. At the end
of the tube is a flap that regulates the distance the snow is thrown. Turn up the handle that
locks the pierced rod, move the rod to the desired position and lock it again.
A hydraulically (or electrically) operated flap is available as an option. This is suitable for those
that need to change the placing of the ejected snow while operating the equipment.
Mechanical flap control (Standard)
Hydraulic flap control (Option)
Locking handle
for mechanical
flap control.
Skrews that must be
be taken away, when
the height is adjusted
at the support pads.
.
