8
9
JUG CLEANING AND MAINTENANCE
To clean the 2 Litre and 1 Litre Rotating jug:
1.
After each use, rinse the jug thoroughly with warm soapy water (not hot).
2.
Place one to two drops of dish soap in your jug and fill it halfway with warm water.
3.
Secure the lid in place.
4.
Press and hold ‘pulse’ for a few seconds (depending on what was blended, thick contents take
longer to clean).
5.
Pour contents out and rinse thoroughly.
6.
Turn the jug upside down and let air dry.
7.
Check the base of the jug where the cog is (bit that connects blade to bender motor) if this
section has been wet by this process; please thoroughly dry it with a towel to ensure the
bearing is not water damaged.
For a deep clean, perform the following steps monthly or as needed:
Fill the blending jugs with one third of cool water and another third with white vinegar and let it soak
for between 12 and 24 hours. Pour contents out and rinse thoroughly. Then, follow the appropriate
cleaning instructions above.
If the blade assembly tarnishes:
Quite often a surface build-up does occur even with stainless steel (orange tarnishing/going
dull) and often you can soak the jug for 24 hours with neat white vinegar just covering the blade
assembly and then follow the appropriate cleaning instructions above. Anything left on the blade
after this process in respect to discolouration will not affect anything blended or come off into your
jug contents.
DO NOT SUBMERGE YOUR JUG IN A SINK OR ATTEMPT TO WASH IT
IN A DISHWASHER. THIS WILL CAUSE IRREVERSIBLE DAMAGE TO
THE BEARINGS.
BLENDER CLEANING AND MAINTENANCE
You must always clean your blender after use, this is for hygiene and ensuring the longevity of your
Optimum™ high-speed vortex blender. Leaving food in the blender is a health risk as bacteria can
grow and cause staining on the jug. Bacteria and residual food acids can also damage the seals and
shaft to the blade.
To clean the base:
1.
Unplug the blender from the power.
2.
Using a soft, damp cloth, wipe the surface of the blender base, you can use a mild detergent to
remove dried food if required.
3.
Use a dry soft cloth to thoroughly dry the blender.
To clean the cushion pad:
1.
Disassemble the blender by lifting the jug from the base.
2.
Remove the cushion pad from the base by grasping each corner of pad in turn and lifting away
from the base unit.
3.
Wipe the cushion pad using a mild detergent and damp cloth, you can submerge this section
into a sink if required.
4.
Towel dry after cleaning.
5.
Clean the top of the blender base under the cushion pad with mild detergent and a damp
cloth, any liquid or food residue left on the base can be sucked into the motor and cause
significant damage.
6.
Put the cushion pad back on the base unit by fitting each corner of the pad and pushing
downwards until it is flush with the base unit. This cushion pad must be attached firmly and
securely to the base unit before use, and ensure that the drive socket is has clearance above
the cushion pad.
DO NOT PUT ANY PART OF YOUR BLENDER IN THE DISHWASHER OR
IMMERSE THE BLENDER BASE IN WATER.