OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 1.0 dated 2015-06-18
Page 5
Original operating instructions
S275N | S275NV
GB
1
Safety
Glossary of symbols
This part of the operating instructions
explains the meaning and use of the warning notes included in these operating instructions,
defines the intended use of the metal belt saw ,
points out the dangers that might arise for you or others if these instructions are not
observed,
informs you about how to avoid dangers.
In addition to these operation instructions, please observe
the applicable laws and regulations,
the statutory provisions for accident prevention,
the prohibition, warning and mandatory signs as well as the warning notes on the metal belt
saw.
European standards must be kept during installation, operation, maintenance and repair of the
circular metal saw.
If European standards have not yet been incorporated in the national legislation of the country
of destination, the specific applicable regulations of each country must be observed.
If required it is necessary to take the corresponding measures to comply with the country-spe-
cific regulations before commissioning the metal belt saw.
Always keep this documentation close to the metal belt saw.
INFORMATION
If you are unable to rectify an issue using these operating instructions, please contact us for
advice:
Optimum Maschinen Germany GmbH
Dr. Robert-Pfleger-Str. 26
D- 96103 Hallstadt
Email: info@optimum-maschinen.de
1.1
Type plates
provides further instructions
calls on you to act
enumerations