7
BEFORE YOU MAKE THE
CONNECTIONS
The supplied connection cables in-
clude all the lead wires you need to
connect the amplifier to your existing
autosound system, ground, and pow-
er.
Important: Do not cut these wires. If
you cut any wire, you cannot obtain a
refund or exchange on this product.
RadioShack will provide warranty ser-
vice if you cut a wire and find the prod-
uct is defective.
If the connectors on your vehicle’s au-
tosound system are not compatible
with the amplifier’s connectors, you
might need an adapter harness to
complete the connections. Ra-
dioShack stores sell adapter harness-
es for most vehicles.
You might need additional wire, de-
pending on your individual autosound
system, to complete the connections.
Your local RadioShack store carries a
full line of wire and wire management
accessories.
Cautions:
• For added safety and to protect
your amplifier and autosound sys-
tem, disconnect the cable from
your vehicle battery’s negative (–)
terminal before you begin.
• Be sure your speakers can handle
as much as 500 watts of power
(250 watts per channel if you con-
nect the amplifier to one pair of
speakers, or 125 watts per chan-
nel if you connect the amplifier to
two pairs of speakers). Each
speaker must have an impedance
of at least 4 ohms. Your local
RadioShack store carries a full
line of speakers.
(illustration)
12-2010.fm Page 7 Tuesday, July 13, 1999 2:10 PM
