UMX-TEL version 4.3.000AS
7
UMX-TEL
(ASIA VERSION)
DTMF Telephone interface card
for UMX-03/0 audio matrix
3.2.
CONFIGURATION OF THE CALL
This defines the mode in which we communicate with the card by means of the DTMF tones of the telephone call. Access to this
configuration is gained by pressing the rear “CONFIG.” button and making a call through the telephone connection. Once the card
answers,
10 digits must be entered
. Each digit configures a different parameter.
3.2.1.
CONFIGURATION PARAMETERS
The programmable parameters are:
Digit / Parameter
Description
Values
1
First digit of the password
0 to 9
2
Second digit of the password
0 to 9
3
Third digit of the password
0 to 9
4
Number of call tones before card answers
1 to 9
5
Debug mode
0 to 3
6
Number of digits for calling zones or groups, or fix call
0 to 4
7
Detection time of DTMF “1” hanging up tone
0 to 9
8
Hanging up tone detection time
0 to 9
9
Noise gate (0: deactivated / 1: activated)
0 to 1
10
Maximum message time
0 to 9
•
PARAMETERS 1, 2 and 3: PASSWORD
These establish the three digits of the password:
P1
P2
P3 DESCRIPTION
0
0
0
Without password: the call is made and the card answers after the dialling tones configured.
X
X
X
The password is X X X: the call is made, the card answers and the password must be keyed in from the
telephone.
•
PARAMETER 4: CALL TONES
This configures the number of tones after which the card will answer when a call is made to broadcast a message (between 1 and
9).
NB: In the case of the configuration call, the card always answers after two call tones.
•
PARAMETER 5: DEBUG MODE.
Set this parameter to
0
(debug mode OFF).