UMX-TEL version 4.3.000AS
10
UMX-TEL
(ASIA VERSION)
DTMF Telephone interface card
for UMX-03/0 audio matrix
3.2.3.
CALL CONFIGURATION PROCESS
To change the parameters, it is necessary to make a configuration call as described below:
1.
Press the rear button
CONFIG
. The
CONFIG
. LED will start to blink quickly. The user has approximately 60 seconds to make the
call and send the configuration parameters.
2.
Dial the telephone number (or extension) corresponding to the UMX-TEL telephone adaptor from a tone dial telephone. The
unit will answer on the second call tone, the
CONFIG
. LED will remain lit and three different tones will be heard through the
telephone receiver.
3.
Key in the 10 digits corresponding to the 10 configuration parameters. 3 identical tones will be heard through the telephone
receiver to confirm reception of the configuration and the
CONFIG.
LED changes to READY mode (slow blink).
4.
Hang up the telephone.
4.
OPERATION
Once the card has been configured by following the steps described in the previous sections, access can be gained to the PA system
from the telephone by dialling the number corresponding to the telephone line connected to the card.
4.1.
BROADCAST OF A MESSAGE WITHOUT A PASSWORD
1.
Pick up the telephone.
2.
Dial the telephone number corresponding to the card.
3.
Wait for the card to answer after the established call tones (from 1 to 9 depending on the configuration).
4.
The card answers and emits a series of short tones.
5.
If the card is configured with selection of zones or groups, enter the digits of the zone (or group) where it is wished to
broadcast the message.
If no number is entered in 9 seconds, the card emits short tones and then hangs up.
If the zone entered is busy due to an announcement of higher priority, busy tones will be heard and the card will hang up. The
same will occur if the destination unit is a group and all the zones in the group are busy. If the group has free zones and busy
zones, the calling process continues.
6.
Once the zone (or group) number has been entered, a long tone will be heard, indicating that the message can now be
broadcast. At the end of the message, hang up the telephone or press “1”. By default, the system will hang up automatically
once the communication time defined when the card is configured has elapsed.
4.2.
BROADCAST OF A MESSAGE WITH A PASSWORD
1.
Pick up the telephone.
2.
Dial the telephone number corresponding to the card.
3.
Wait for the card to answer after the established call tones (from 1 to 9 depending on the configuration).
4.
The card answers and emits a series of short tones.
5.
Enter the three digits corresponding to the password.
6.
If the card is configured with selection of zones or groups, enter the digits of the zone (or group) where it is wished to
broadcast the message.
If no number is entered in 9 seconds, the card emits short tones and then hangs up.