User Manual – ePX 200
OptiPro Systems, LLC.
Page 41 of 60
Last Modified: 7/30/2014
Move on to the Polishing Setup page after all the parameters are entered correctly. The tram check
simulates polishing the gauge ball, so you will enter most of the parameters into the Cycle Number 1
column. The required parameters are listed in Table 7-5.
Table 7-5: Summary of Polish Setup Screen Parameters
Parameter
Value
Pause at Gap Height
Checked (This must be selected)
Tool To Lens Gap(mm)
0.001
Part Drop Gap(mm)
10
Unloading Pressure(bar)
0
Starting Position(mm)
4.900
Stroke Distance(mm)
12
Oscillations Per Minute
1
Bladder Pressure(bar)
0
Tool Speed(RPM)
0
Speed Factor
1
Cycle Time (min)
5
