1
Attentions
!!
1. Purpose
This series microscope is used only for microscopic observation , not available for other
purpose, otherwise result in equipment damage.
2. Disassembly only by the professionals
The microscope has been adjusted before shipping, Unprofessional-person should not
disassemble and remove any other parts. Disassemble and remove any other parts will
result in equipment damage .
If you have any questions, please contact with manufacturer or local distributor.
3.
Note the input voltage if
correspond.
This instrument designed for wide input voltage (100V~240V, 50/60HZ), applicable to
most area .But if the supply voltage exceeds this range, the instrument will be seriously
damaged.
4. Prevent Burns And Fire
When using power equipment, bulbs and collecting mirror and other nearby parts of the
set will rise sharply in temperature until it reaches a thermal equilibrium state. Pay
attention to anti-hot logo, they should be careful not be burn when in use.
Alcohol, gasoline, paper and other flammable materials can’t near the lamp in case
of fire.
5. Notes On Replacing The Bulb.
Replacement should be based on the identity of the instrument using the same
specifications of the bulb, otherwise it may cause equipment damage.
The power supply must be cut off before bulb replacement, the bulb must be cooled off
completely before proceeding! !
6. Carry
Power must be cut off before moving. Be careful not to crush your finger when placed.
This instrument is a precision instrument, and it should be handle with care, severe shock
can cause serious damage to equipment-related parts.
7. Installation
Please refer to the installation instruction in order to avoid to damage the instrument .
8. Operation Environment
The required available environment for using of the equipment:
Indoor temperature: 0
℃
~ 40
℃
maximum relative humidity: 85%
High temperature or high humidity may cause mildew, fog or dew of the optical
components, and make the instrument not work.
9. Packing Waste Disposal
For the protection of the environment, please properly handle the microscope packing
waste or send to
salvage station
(
such as: cardboard, foam, etc. )!