4
binocular head 11
、
adjusting screw 12
、
camera socket 13
、
Camera
interface 14
、
9.7 inch touch display 15
、
eyepiece 16
、
tie rod 17
、
magnification correction wheel 18
、
reflector 19
、
Stage 20
、
workbench
21
、
Worktable X-axis movement knob 22
、
Worktable Y-axis movement knob
四、
Instrument installation and focusing
1
．
installation, focus
1
）
Fit the binocular head (10) and insert the same required eyepieces (15) into the two
tubes of the binocular head.
2
）
Insert one end of the power cord into the power socket on the back of the base, and
connect the other end with a grounded 220V power supply.
3
）
Press the main power switch (1).
4
）
Place the specimen and sample on the two stage surfaces.
5
）
Turn the left and right magnification adjustment knobs (8), so that the left and right
systems are in the same objective lens magnification state.
6
）
Turn the coarse motion linkage lift knob (3) and observe through the eyepiece until the
image of the object placed on the table is observed. Then turn the left and right stage lift
knobs (5) until the two images are equally clear. If the ridge line (split line) in the field of
view is not clear, turn the eyepiece diopter circle to adjust the diopter.
五、
Function and Operation
In order to obtain the best use effect of the instrument, it is necessary to have a detailed
understanding of the functions of each part of the instrument, and master the adjustment or
operation methods.
1
．
Operation of the stage: rotating the handwheel (5), (21), (22) the stage can move left and
right, front and rear, and up and down respectively; the table can be rotated 360º; the table
can be tilted by a certain angle; The horizontal linkage knob (4) enables the linkage of the
two stages.
2
．
Adjustment of the light source: The light source is 12V50W halogen tungsten lamp, there
is a micro cooling fan behind the lamp holder, the lamp holder can be rotated around the
stage to any direction; the illumination angle of the lamp on the table can be changed with
the help of the lamp bracket; press the button on the touch panel. The light intensity
adjustment key can change the light intensity of the lamp; the plug socket can be inserted
