V 1.0 - eng
5
PCHI023-AF
| INSTRUCTIONS MANUAL
5. PINOUT AND CONTROLLER
5.1. Connector and pinout
The PCHI mounts a circular 6-pin male connector,
whose part number is
HR10A-7R-6PB(73).
The figure on the right represents the connector.
Note that some of the pins are not used.
In particular, the connector pinout is described in the
following table:
5.2. Compatible controllers
The PCHI tunable lens
must be controlled by a suitable lens driver.
Only the following part numbers are considered fully compliant with the PCHI023-AF.
CBGPIO6PMF-3M
, 6 Pin Hirose Male - Female moulded connector cable, 3 m
RT-EL-E-4i
, USB driver for electrical lenses, Industrial housing with 6-pin Hirose connector, Output
current: 0 to +/-250 mA, I2C sensor read-out.
Opto Engineering doesn’t respond for product damages and malfunctioning if other drivers
are used. Check the manufacturer website for the driver installation and configuration.
Contact your Opto Engineering Area Manager for more information on pricing and availability.
Pin number
Description
1
Lens + control pin
2
Lens - control pin
3
Not connected
4
Not connected
5
Not connected
6
Not connected
1
2
Reference mark
