PX-35 SSxxxxx
17
12. Regulatory Compliance
12.1. LED Safety
Lamp classification: IEC62471:2006 Exempt Group
12.2. LASER Safety
・
IEC 60825-1:2007 Class 1
・
CDRH Class I
12.3. Product Safety
・
IEC60950-1
・
EN60950-1
12.4. EMC
・
EN55022
・
EN55024
・
FCC Part15 subpart B Class B
・
FCC Part15 subpart C
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Federal Communications Commission Notices
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Harmful Interference Notice
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used according to the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which is found by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
Changes or modifications to this equipment that have not been approved by Ruckus Wireless may void the
user's authority to operate this equipment.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.