Copyright 2011 Bit Cauldron Corporation
Page 7 of 24
Manual Performance Tuning Mode: Using the Joystick to Manually Tune Performance
Mode
During performance tuning, the Optoma 3D-RF Emitter continues to provide 3D sync to the Optoma 3D-
RF Glasses. The joystick modifies parameters, while the LEDs display the current value of the parameter
being adjusted. While wearing the Optoma 3D-RF Glasses and viewing 3D content on the projector,
hold the Optoma 3D-RF Emitter and adjust the parameters to the desired settings.
WARNING: THE MANUAL PERFORMANCE TUNING MODE ENABLES THE USER TO PLACE THE GLASSES IN
A MODE IN WHICH ONE EYE SEES A DOUBLE IMAGE CONSISTING OF PARTS OF BOTH THE LEFT AND
RIGHT IMAGE. THIS CAN CAUSE EYESTRAIN. IF YOU EXPERIENCE EYESTRAIN, PLEASE DISCONTINUE USE
OF THE PRODUCT IMMEDIATELY. TO MINIMIZE THE CHANCES OF EXPERIENCING EYESTRAIN DURING
MANUAL PERFORMANCE TUNING, PLEASE OPEN ONLY ONE EYE AT A TIME. THIS METHOD ALSO MAKES
IT EASIER TO PERFORM PERFORMANCE TUNING. AFTER EACH EYE SEES A UNIQUE IMAGE, OPEN BOTH
EYES AT THE SAME TIME TO CHECK THE POLARITY.
LED Display During Performance Tuning
When the device enters manual performance tuning mode, the display will change from two green LED’s
to some number of red LED’s indicating the current delay. [Note: if the delay has previously been tuned
to the minimum value, the displayed value will correspond to zero and all LED’s will appear dark.]
To provide adequate time for adjustment and observation of the current settings, performance tuning
mode stays active for two minutes after the user stops operating the joystick. Following the inactivity
period, the performance tuning settings will be saved and the Optoma 3D-RF Emitter will return to
normal operating mode.
See the appendix About Performance Tuning for a detailed explanation of shutter glass function and
performance tuning.
Delay Tuning
Moving the joystick up and down will change the delay between when
the “Open Left” signal is received by the emitter and when the left lens
opens. (The delay of the right lens will also be changed in lockstep, as will
the lens closing times.)
UP = INCREASE DELAY, GAUGE GOES UP
DOWN = DECREASE DELAY, GAUGE GOES DOWN
