OPT-6016
Manage Operating Instruction
www.optone.net
5
2.2.4
Usage of [enable]
1
、
enable 1 –
enable port 1
2
、
enable all –
enable all ports
2.2.5
Usage of [disenable]
1
、
disenable1 –
disable port 1
2
、
disenable all –
disable all prots
2.2.6
Usage of [mode]
There are three kinds of modes: [serdes], [sgmii] and [auto]. [serdes] is the default mode. When
you insert 10/100/1000M copper SFP to the model, you need to change the mode from [serdes]
to [auto] or [sgmii].
1
、
mode 1 sgmii –
set the port 1 to [sgmii] mode
2
、
mode all auto –
set all the ports to auto identification mode
2.2.7
Usage of [rate]
Configure bandwidth of the port (Need to use cooperatively with command “suppression” under
the second level menu “config”). Command [suppression] includes two control blocks, bucket0
and bucket1. Each control block controls the turn on/off status of unicast, multicast, and
broadcast’s flow control. Command [rate] is the second level switch, which determines the exact
port and the bandwidth of the port. Default configuration: bucket0 controls broadcast; bucket1
controls unicast and multicast. [rate] controls all ports are turned off by default.
1
、
rate 1 enable –
enable flow control of port 1
2
、
rate 1 disable –
disable flow control of port 1
3
、
rate 1 b0 2 –
the max bandwidth of the packet controlled by bucket0 of port 1 is 2*8=16M
(the max is 1000M)
4
、
rate 1 b1 2 -
the max bandwidth of the packet controlled by bucket1 of port 1 is 2*8=16M (the
max is 1000M)
2.2.8
Usage of [status]
1
、
status 1 show –
show status of port 1
2
、
status all show –
show status of all prots
