USB Server Gigabit
– Quick Start Guide
ACPIUSBSGB-QSG-E2017-07-A
6/8
2. Connection USB Server Gigabit [ACPIUSBSGB] via Network
Installation
On a connection to a PC both over the network, the USB server as well as the PC must use an automatic IP
address. Here the DHCP server is available. Review the following settings on your PC once (depending on the
operating system the procedure can differ from the here shown
– the following description refers to a Windows 7
system).
1. Go to
Control Panel
; open
Network and Sharing Center
.
2. Enter
Local Area Connection
– status screen
[1]
is shown and subsequently
Properties
.
3. Mark
Internet protocol Version 4 (TCP/IPv4)
[2]
and go to
Properties
again
.
[1]
[2]
[3]
4. In the register card
General
enable the checkbox
Obtain an IP address automatically
[3]
The default setting for the USB server is DHCP. If you have not previously used the
WuTility
program, you do not
have to start it. If you have already used it before, e.g. a direct connection, make sure that the following setting is
configured:
