User’s guide CS 2208 CD
Operation:
•
The equipment should be placed on a level floor
•
Before plugging in the equipment, ensure that main switch is in “0” position
•
Set the main switch into „I” position – green diode will be on
•
Insert paper into the feed slot on the top. NOTE! Paper should be only put in the middle of the slot
•
The equipment will start automatically after inserting the paper
•
Maximum paper width of 220mm. If the pages are wider, cut or fold to fit the slot. You can only shred 8 sheets of 80
g/m² paper at a time
•
Shredding credit cards. The shredder shreds only
one
credit card or
one
CD/DVD at a time
•
It is impossible to shred paper and credit cards or CD/DVDs at the same time
•
After 10 minutes of continues work electric motor will overheat and machine stop immediately. Red diode will be on.
Wait 20 minutes until it cools down
•
Turn the power switch off when shredding is finished
•
If too many pages of paper are inserted into the slot, it will cause the paper to jam inside the cutting blades
•
Pull out the surplus jammed/stuck paper and slide the switch to REV to (reverse) the paper out and then switch to
“FWD” (forward) to shred any paper scraps left in the cutting blades
•
If it will not solve the problem, contact the dealer or the service team
Cleaning:
•
Before clearing the shredder ensure that the main power switch is switch off then unplug the equipment from the
mains socket
•
When the shredded paper bin gets overfilled, it may cause problems and paper will go inside the mechanism feed
and there is a risk of fire. Pull the bin out, remove shreds and re-install the bin under the shredder
•
To avoid problems please clean the shred bin regularly before it overfills
•
Cleaning the housing. Wipe the cover of the shredder with gentle home detergent or a damp piece of cloth.
•
Do not put the equipment into water
•
Do not wipe the unit with petroleum, thinners, alcohol or solvents “” they can cause permanent damage to the
housing and the plastic
Maintenance:
•
To prevent reduction of efficiency, increased sound levels and to prolong the lifespan of the
equipment, it is necessary to oil cutting blades regularly.
•
After filling the waste bin several times, the blades should be oiled with a special oil (provided by OPUS).
•
Put a little oil on a few pieces of paper and shred them so that the oil will spread on the whole cutting mechanism.
Possible malfunctions
Malfunction
Possible Cause
Remedy
Equipment does
not start after
inserting paper into
the slot
1. Not plug in properly
2. Pages to be shred are too soft
3. Overheating
4. Paper jam
5. The basket is not installed
properly
1. Plug the equipment in correctly
2. Fold pages or insert more paper in the feed
opening
3. Turn off the shredder, wait about 30 min
Turn on once again
4. Remove stuck paper
5. Install shred bin correctly
Equipment does not
stop after shredding
Photo cell in the entry slot is
covered by scraps of paper
Clean the photo cell
The shredder
operates too loud
Equipment is not on sturdy and level
floor
Place the machine on study and level surface
and lock front wheels
