2 RECOMENDATIONS
•
Use only recommended supplies and accessories.
•
The equipment is designed for lamination with pouch 25 – 250μm. Do not use different
pouch thickness.
•
Individually cut pouch can badly dirt the rolls or wind around them.
•
Remove all metal elements (clips, clamps, etc.) before laminating the document.
NOTE!
Not complying with the recommendations above can result with warranty void.
OPUS RolLAM 380 • User guide
GB
9
3 ASSEMBLING AND OPERATING
•
Install the top and bottom film brackets using screws supplied.
•
Apply on the rollers laminating foil, next stabilize it with adjustable collars.
•
Put the rollers with foil on to brackets.
•
Install upper foil using below diagram:
Instrukcja obsługi / User guide
OPUS rolLAM 380
9
Assembling and operating
Install the top and bottom film brackets using screws supplied.
Apply on the rollers laminating foil, next stabilize it with adjustable collars.
Put the rollers with foil on to brackets.
Install upper foil using below diagram:
Roll with foil
Foil Safety cover
Hot rollers
Guide table
Install the bottom foil using the diagram below:
Hot rollers
Foil
Roll with foil
Install safety cover and guide table.
Set the temperature and speed required.
Laminate a piece of same material too check if foil on the rollers is tensioned well.
If not, adjust them using knobs on rollers or with the roller tension handle. The handle is on the
right side of equipment.
The equipment is ready to use.
•
Installthe bottom foil using the diagram below:
