OPUS SpeedLAM A3 • User guide
GB
11
MEAS:
Shows current temperature.
STOP:
Stop function.
REV:
Reverse function.
MEMO:
This button is for keeping In memory your own temperature settings. Push the
MEMO button for 5 seconds until its flashes. Then you may set your own
temperature using numeric buttons.
5 CLEANING
• Low lamination quality and marks on the pouch, wipe with domestic cleaner.
• Dirty rollers, set the temperature on 60˚C speed 2.
• Run several sheets of paper to remove the dirty if this does not work call the service team.
• To clean the cover of the laminator wipe with a cloth with some domestic cleaner
Do not use petroleum or alcohol based cleners.
• Always disconnect the power when cleaning the device.
• If the film has been pulled into rollers or the laminator is not working properly,
contact the service centre.
PROBLEM
CAUSE
SOLUSION
Laminator is inoperative
or the roller does not rotate.
Power plug is not plugged in.
Power switch is off.
Check the Power plug is
properly plugged. Check if the
Power switch is turned on
or contact support.
Excessive noise.
Operation of rollers is not
smooth.
Turn off the machine, contact
support.
Bad laminating.
Laminated document
wrinkled, damp or folded.
Turn off the machine, contact
support.
The temperature does not rise
for a long time.
Check power plug.
Check if the Power plug and
switch is turned on. Contact
support.
Corners are not sealed.
Document is to thick to seal
the edges of the film.
Use a thinner document or
leave more around the edges,
about 5 mm.
Wrong operation.
Something is between the
rollers.
Call the dealer or service
team.
6 POSIBLE MALFUNCTIONS
In case of any other problems switch off the equipment, remove the plug from the
socket and contact the service team.
