Document No.: M00-20-6000, Rev. 02
Page 6 of 13
2
OPW Ethernet
IP Authorization Gateway
Installation
Prior to the installation of the OPW Ethernet IP Authorization Gateway, an initial site assessment, gateway requirements and
network connectively must be established. Next, follow the installation procedure for connecting the OPW Ethernet IP
Authorization Gateway.
IMPORTANT
: Never press the
reset
button on the Cellular Gateway. This will erase the program and it will have to be
reloaded. There is a fee associated with reloading the program.
NOTE
: If you have any questions, contact the OPW Help Desk at
1-877-679-8324
and select
Option 1
for Fuel
Management Systems. Tell the Help Desk technician that you are installing an OPW Cellular IP Connection and provide a
description of the problem you are experiencing.
2.1 Site Assessment for the OPW Ethernet IP Authorization Gateway
For NBS (20-6001), Paymentech (20-6002), or Buypass (20-6003) network users, prior to installation, the site assessment must
be completed and the OPW Site Request Form must be faxed to the number at the top of the form, after which network users
must activate their SSL NOC Account, which will be sent to the site owner via email.
NOTE
: There is a monthly charge for an SSL NOC Account.
IMPORTANT
: The OPW Site Request Form must be submitted 48 hours prior to your planned install time.
Prior to installing any version of the Ethernet IP Gateway, collect the following information or provide this document to the IT
Manager so that the following information can be filled in.
•
Is the LAN (internal) network at the site DHCP-enabled (dynamic)?
Yes
No
•
Are there any outbound port-blocking rules in place on the network?
Yes
No
NOTE
: If the network is DHCP-enabled and no outbound ports are blocked, skip to Section 2.2, Requirements for the OPW
Ethernet IP Authorization Gateway. Otherwise, proceed with the information as follows below.
NOTE
: The following ports must be open for outbound traffic (53, 80, 123, 443, 10001, 10002).
IMPORTANT
: If the site chooses to use the Inbound Communications option, then a Static IP Address must be programmed
into the unit regardless of whether the LAN is dynamic or static, and the below information must be provided.
•
If this is a
Static IP
LAN environment, what IP Address can be used:
________ : ________ : ________ : ________
•
What is the
Subnet Mask
: ________ : ________ : ________ : ________
•
What is the
Default Gateway
: ________ : ________ : ________ : ________
•
What is
DNS (Domain Name Server) 1
: ________ : ________ : ________ : ________
•
What is
DNS (Domain Name Server) 2
: ________ : ________ : ________ : ________
If a
Static IP Address
is required, the OPW Help Desk will configure it for you once you have completed the following steps:
