Oracle Audio Technologies
17
ATTACH THE PHONO LEAD
( Does not apply with the granite base option )
•
Plug the phono lead to the base of your tone arm.
•
Retrieve the strain relief device from the packaging.
•
Secure the lead to the strain relief device form above or below the plinth.
•
Create a loop from the base of the tone arm to the strain relief device to prevent any interference of the
lead with the suspension system. Make sure the looped wire does not come in contact with the table
below.
Note :
In some applications, the phono lead might be too stiff. It is recommended to split the moulded wire
from the plug to the strain relief. If the loop is too long, the lead could come in contact with the table below. If it
is too short, it will prevent the suspension system from moving freely. In both cases, this would be detrimental to
the sound.
CONNECT THE POWER SUPPLY
•
Plug the power supply output to the turntable input receptacle located to the rear of the turntable.
•
Plug the input cord to an AC outlet.
Note :
Keep the power supply away from signal carrying leads. The power supply can remain connected to the
wall outlet unless you don’t intend to use the turntable for a long period of time.
ADJUST THE 33 AND 45 SPEED