Oracle Audio Technologies
Paris PH200 phono stage
5
Ohms load impedance setting. To avoid saturation at the signal input of your Ph
200 it is highly recommended to start by setting the gain to the minimum level of
41,5dB. Should you need to set your integrated amplifier or pre-amplifier volume
level very high for a comfortable listening level it is suggested to then use the
next higher value of gain, 52 dB. If you need still more gain then move the load
jumpers to the last gain setting option of 62 dB.
Fixed capacitive charge
The 47k Ohms setting is coupled with a fixed capacitive charge of 150pF. There is no
capacitive charge for the moving coil resistive load settings.
Factory settings
The default factory gain setting is set at 41.5k, the load impedance setting is 47k Ohms.
This represents the required setting for a moving magnet cartridge.
IMPORTANT NOTE ABOUT JUMPER POSITIONING
1 ) ONE JUMPER MUST ALWAYS BE INSTALLED ON
ONE OF THE 3 "GAIN" JUMPER POSTS
2 ) THE SECOND JUMPER MUST BE INSTALLED ON
EITHER … ONE OF THE
5
M/C LOAD POSTS
OR
ON THE M/M 47K ohms POSTS
3 ) FOR M/M 47K ohms SETTING ALWAYS
USE THE 41,5 db GAIN SHORTING POSTS
Gain 62 db
Gain 52 db
Gain 41.5 db
No Connection
M/M 47K ohms
M/C 100 ohms
M/C 200 ohms
M/C 511 ohms
M/C 1k ohms
M/C 1,5k ohms
Gain and resistive load settings for the Paris PH-200 by Oracle
