HBA Connectors
Appendix A • HBA Specifications
47
Specification
Operating
Non-Operating
Humidity
5% to 90% RH, non-condensing, 40˚C max, 27˚C max
wet bulb, 16-hour dwells at extreme
93% RH, non-condensing, 40˚C max, 120 hours
Altitude
3200m at 40˚C, 4-hour dwells
12,200 m at 0˚C, 4-hour dwells
Vibration
0.25 G in all axes swept for 5-500-5 Hz, 5 sweeps in
all at 1 octave/min
1.2 G in all axes swept for 5-500-5 Hz, 5 sweeps in all
at 1 octave/min
Shock
5.5 G, 11 ms half-sine, 10 shocks in x-, y-, and z-axes
33 G, 11 ms half-sine, 3 shocks in x-, y-, and z-axes
Airflow
At least 200 linear feet per minute (LFPM)
At least 200 linear feet per minute (LFPM)
HBA Connectors
This section provides a description of the different connectors on the host bus adapter.
■
PCIe Connector (J6). Supports x8 interface. The PCIe connection is through the edge
connector, J6, which provides connections on both the top (J6B) and the bottom (J6A) of
the board. The signal definitions and pin numbers conform to the PCIe ExpressModule
Card Electromechanical Specifications, Revision 1.0.
■
UART Connector (J5). Debug port requiring a special cable and Oracle support to gather
detailed IOC status.
■
SAS/SATA Connectors (J3 and J7). Supports SAS connections through connectors J3 and
J7. These connectors are SFF-8088 mini-SAS, external connectors.
lists the UART connection Pins on the HBA.
TABLE A-3
UART Connections
Pin
Function
1
UART_TX
2
GND
3
UART_RX
4
3.3 V
Summary of Contents for SGSAS6-EM-Z
