take significant time depending on the number of modules in the library, so
plan accordingly.
5.
Optionally, select Set the Library back Online to automatically bring the library
online after the test (the library goes offline to perform the self test)
6.
Click OK to start the test.
Note:
If the test fails, click Degraded to open a health table identifying a failed
or degraded component. See
Use the Health Table to Diagnose the
7.
If you did not check the Set the Library back Online checkbox, remember to
bring the library back online manually, once you are ready. See
.
Restore the Factory Default Configuration
Restore the library to factory defaults settings to erase the existing configuration.
Record any important library configuration information because restoring will erase all
configuration information. Only reset the configuration as a last resort.
1.
This procedure requires two people. One person at the front of the library and one
at the rear. A single person cannot reach both buttons simultaneously.
2.
Find the locator buttons — front upper left and rear top center (see below)
3.
Push and release either one of the locator buttons.
4.
Once the locator buttons light, simultaneously push and hold both front and rear
buttons for about 10 seconds until the lights rapidly flash.
Chapter 9
Troubleshoot the Library
9-12
