Installing the Switch
97
3. Compare what you see to the following table.
4. Verify the fabric card status.
See
“Verify the Fabric Card Status” on page 97
Related Information
■
Switch Administration
, checking status LEDs
■
“Check the Power Supply Status LEDs” on page 80
■
“Check the CMC Status LEDs” on page 80
■
“Check the Line Card Status LEDs” on page 103
■
“Check the CXP Connector Status LEDs” on page 115
▼
Verify the Fabric Card Status
1. Identify the prerequisite and subsequent tasks you must perform in
conjunction with this procedure, to install the switch.
See the table in
“Installation Sequence” on page 20
2. On the CMC, verify that the installed fabric cards are active:
If an installed fabric card is shown to be
INACTIVE
, investigate why.
Glyph
Location Name
Color
State and Meaning
Left
Ok
Ready-to-
Remove
Green
On – Normal operation at full power.
Off – No power at all applied.
Flashing – Fabric card has been disabled and is ready to be
removed, standby voltage available.
Center
Attention
Amber
On – A fault or critical error has been detected.
Off – Normal operation.
Flashing – No function.
Right
Locator
White
On – No function.
Off – Normal operation.
Flashing – The fabric card is identifying itself.
#
showpresent | grep FC
