Assembly Instructions
Page 5 of 8
WA
LL
WA
LL
Step 1:
CAUTION:
Avoid pinch points when opening or
closing the
shelter frame.
● Remove
shelter from carry bag.
Remove the tie strap from around the
shelter.
● Lay the
shelter flat on the ground and check
that there is no material twisted or overlapping
the ends of any poles. Do not force
shelter when
folding or unfolding. Watch for the entanglement
of poles.
(Fig.1)
● Grab the webbed loop attached to the steel ring
at the center of the wall and pull outward until
the
shelter wall is partially open.
(Fig.2)
NOTE: The (2) side walls should be popped
open first after laying flat.
Step 2:
● Proceed by walking around entire shelter and
pulling on each wall webbed loop to pop out
each wall until all sides are popped out.
(Fig.3)
● Continue to open the roof.
Roof
FIGURE 1
FIGURE 2
FIGURE 3
