Airplane
Servo setup
Servo Setup adjusts the Servo Reverse, End point, Sub-Trim for all six channels.
Press and hold the Roller button to main menu and select “Servo Setup”
Press the Roller button to select “Reverse”, “End point” and “Subtrim”
Reverse
The Reverse function is used to correct a servo or motor’s direction in relation to the systems
controls. For each channel the user can toggle a reverse state based on demand.
This Reverse function individually reverses the direction of operation of servos on the 6 channels.
This menu contains 6 check boxes, one of each channel.
Setup:
1. Press the Roller button to select channel
2. Move the Roller button to left or right to select “Nor” (Normal) and “Rev” (Reverse)
3. Press and hold the Roller button to save and exit
4. OR press the cancel key to exit without saving
1. Install a bind plug into BIND connector. In case if you want to disable telemetry function on the
receiver, install second bind plug into THRO connector.
2. Apply power to the receiver. It can be from 3.7 to 9.6 volts DC. Please refer to indicator on the
receiver for the correct pinout (GND, VCC, SIGNAL)
3. You will see the orange LED rapidly blinking. That means the receiver is in Bind mode.
4. Press and hold the binding key and turn on the transmitter. (Or, turn on the transmitter, press
and hold the wheel to enter the main menu to select model setup, then choose the bind menu to
enter binding mode)
6
6 CHANNEL TRANSMITTER
DIGITAL PROPORTIONAL RADIO
CONTROL SYSTEMPROGRAMABLE SYSTEM
5. The system will display “RX Binding..”. After successfully binding, the transmitter will automati
cally exit this binding menu.
6. Remove the bind plug(s) from the BIND on the receiver
NOTICE:
Remove the bind plug to prevent the system from entering bind mode the next time the power is
turned on.
Sometimes servo inputs or ESC-s with high input load can cause receiver binding in “No teleme-
try” mode. During this binding you will see both orange and red LED blinking. If you want to have
telemetry function enabled please make sure that nothing is connected to Throttle channel during
binding procedure.
