EN - 57 -
•
The lifetime of your appliance is stated and declared by the Department of Industry. The
length of time for retaining parts required for the proper operation of the appliance is 10
years.
Tips for saving energy
1. Install the appliance in a cool, well ventilated room , but not in direct sunlight and not
near a heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low
temperature of the frozen food will help to cool the refrigerator compartment when it is
thawing. This will help to save energy. If the frozen food is put out, it results in a waste
of energy.
4. Cover drinks or other liquids when placing them in the appliance Otherwise humidity
increases in the appliance. Therefore, the working time gets longer. Also covering
drinks and other liquids helps to preserve smell and taste.
5. Try to avoid keeping the doors open for long periods or opening the doors too
frequently as warm air will enter the cabinet and cause the compressor to switch on
unnecessarily often.
6. Keep the covers of the different temperature compartments (crisper, chiller ...etc )
closed
7. Door gasket must be clean and pliable. Replace gaskets if worn.
8. Energy consumption of your appliance is
declared without drawers and fully loaded in
freezer compartmant.
9. For saving energy, do not use volume
between the load limit and the door, along the
load limit line. Load limit line is also used in
energy consumption declaration.
Load limit line label
