13
EN
4
Connect the bases (19) according to the type to create a cross-shaped
base. Screw the base with the screw (16) with the clamp (23) and slide the
supplied feet (17, 18).
5
Release the pipe retaining sleeve (14), slide the base cover (15) and
assemble the extension tube (22).
6
Fit the entire engine body (5) onto the extension tube (22) and secure it
with the retaining sleeve (14) and the screw (8).
Operation
Before using this device for the first time
• Remove all protective foils and packaging material from the device.
1
Connect the fan to the 230V ~ 50Hz power supply.
2
Switch on the fan with one of the three buttons on the switch (13) at the
desired speed of the propeller.
3 If necessary, activate the oscillation mode by pressing the oscillator switch
(4).
Cleaning and maintenance
In order for the fan to function properly, it needs regular cleaning.
1.
Switch off the device, disconnect the power cord from the mains and allow
the motor to cool completely.
2.
Disassemble the device with the reverse procedure as described in the
assembly section.
3.
Clean all parts from dust and dirt.
Use only a slightly moistened cloth for cleaning. Do not use any solvents,
thinners, alcohol, gasoline or abrasive cleaners. The surface may be
damaged.
4.
Loosen the power cord loosely into a suitable location.
5.
Store the device in a suitable location.
